How to deal with the use of fabric inspection machine
Release time:
2024-08-07
Regarding the common fault repair, the common fault of the fabric inspection machine is mainly 8 kinds. For the cause of these different problems, we provide the following brief repair methods for the general readers to refer to. The fabric is skewed, in the fabric inspection a few forward when the “bite dead” situation. This is mainly because the fabric inspection machine guide roller is not flat new led to, equipment operators only need to adjust the guide roller parallelism can be dealt with.
Regarding the common fault repair, the common fault of the fabric inspection machine is mainly 8 kinds. For the cause of these different problems, we provide the following brief repair methods for the general readers to refer to. The fabric is skewed, in the fabric inspection a few forward when the “bite dead” situation. This is mainly because the fabric inspection machine guide roller is not flat new led to, equipment operators only need to adjust the guide roller parallelism can be dealt with.
Cloth rolls are not neatly rolled. Roll cloth is not neat because the circle cloth roller and guide roller is not parallel to the formation of the cloth, so adjust the parallelism of the cloth roller and the guide roller can completely eliminate the problem of uneven roll cloth. Fabric inspection machine guide cloth, roll cloth heavy. The cause of this problem may be the machine's transmission part of the dust, cloth hair and oil, or transmission parts are not well equipped, as long as we correctly equip the transmission parts of the cloth inspection machine, and regularly clean up the machine within the oil, cloth hair will be able to.
Machine noise. Machine noise problem is mostly due to poor machine lubrication, parts wear and tear or screws loose, as well as some of the drive shaft cooperation wear and tear to form a large gap, left and right fluctuations caused by, we can regularly add smooth oil for the equipment, the correct equipment for a variety of parts, corrections, or replacement of damaged or unqualified parts to deal with this problem.
Guide roller or roll cloth roller every turn of the week will occur part of the phenomenon of stagnation. This phenomenon is mainly due to the replacement of bearings and the original parts of the cooperation is not good, guide roller and roll cloth roller shaft damage and zigzagging caused by, can be adjusted through the cooperation of poor equipment parts, and then correct the axis of the zigzagging skew to deal with.
Tag:
Mobile:
Tel:
Add: Dongshe Town, Tongzhou District, Nantong City, Jiangsu Province
Contact: 86-13901468376 Mr. Zhu
Tel: 86-513-82506284 / 86-513-82506333
Fax: 86-513-82506666
E-mail: sales@ntzhongyi.com
Website: http://www.ntzhongyi.com
HUATAO GROUP
Online Message
Please fill in the form below, our staff will contact you within 24 hours and solve your problem as soon as possible.
Copyright©2024 Nantong Tongzhou Zhongyi Textile Machinery Co., Ltd.