When the garment factory uses the fabric inspection machine, in this process, because of its own operating errors or equipment quality doubts, it may show equipment problems. This will produce inaccurate cloth inspection, and it will not work directly when it is severe. It should not be ignored and must be dealt with in time.

The cloth inspecting machine presents a very noisy scene in the process of work, which is likely to be caused by factors such as a large distance between the transmission shaft of the equipment, loose parts in a certain part, and insufficient lubricating oil. Just adjust and replace the parts and replace them. Suitable lubricating oil will do. The cloth inspecting machine shows the jammed state of the cloth during the cloth inspection process. This is probably caused by the skew of the cloth. It has nothing to do with the quality of the equipment itself. The operator only needs to adjust the cloth guide roller according to the correct method to make They can be parallel to each other. The glass plate of the cloth inspecting machine has low brightness, which is mainly caused by a lot of dust and cloth on the glass panel or the brightness of the light pipe is weakened. As long as the dust and cloth are regularly arranged and the light pipe is replaced, it is enough. The cloth inspecting machine did not experience smoothly during the guiding and rolling of the cloth. Such a question may be caused by the accumulation of a lot of dust, cloth scraps, grease, etc. in the transmission position of the equipment, which requires normal maintenance work.