Fabric inspection machine electricity common sense
Release time:
2021-08-30
electrical equipment in factories and workshops, do not casually move. If the electrical parts of the equipment and tools you use are out of order, you should not repair them privately, nor should you run them with faults, but should immediately ask an electrician to overhaul them. 2，自己经常接触和使用的配电箱、配电板、闸刀开关、按钮开关、插座、插销以及导线等，必须保持完好、安全，不得破损或将带电部分裸露出来，如有故障及时通知电工维修。 3、工厂内的移动式用电器具，如座地式风扇、手提砂轮机、手电钻等电动工具都必须安装使用漏电保护开关，实行单机保护。漏电保护开关要经常检查，每月试跳不少于一次，如有失灵立即更换。保险丝烧断或漏电开关跳闸后要查明原因，排除故障后才可恢复送电。 4，使用的电气设备，其外壳按有关安全规程，必须进行防护性接地或接零。对于接地或接零的设施要经常进行检查。需要移动某些非固定安装的电气设备必须先切断电源再移动。同时导线要收拾好，不得在地面上拖来拖去，以免磨损。 5、珍惜电力资源，养成安全用电和节约用电的良好习惯，当要长时间离开或不使用时，要在确保切断电源（特别是电热器具）的情况下才能离开。 6、要熟悉自己生产现场主空气断路器（俗称总闸）的位置（如施工现场、车间、办公室、宿舍等）。
1, electrical equipment in factories and workshops, do not casually move. If the electrical parts of the equipment and tools you use are out of order, you should not repair them privately, nor should you run them with faults, but should immediately ask an electrician to overhaul them.
2, their frequent contact and use of the distribution box, switchboard, gate switch, button switch, socket, plug and wire, etc., must be maintained in good condition, safety, not broken or will be exposed to the charged part of the bare, if there is a failure to notify the electrician for repair in a timely manner.
3, the factory's mobile power appliances, such as seat floor fan, portable sander, hand drill and other power tools must be installed to use leakage protection switch, the implementation of single protection. Leakage protection switch should be checked frequently, monthly test jump no less than once, if any failure to replace immediately. Fuse blowing or leakage switch tripped to find out why, troubleshooting before resuming power supply.
4, the use of electrical equipment, its shell according to relevant safety regulations, must be protective grounding or zero. For grounding or zeroing facilities should be checked frequently. Need to move some non-fixed installation of electrical equipment must first cut off the power supply and then move. At the same time, the wire should be packed, not dragged on the ground to avoid wear and tear.
5, cherish the power resources, develop good habits of safe use of electricity and electricity saving, when to leave for a long time or not use, to ensure that cut off the power supply (especially electric appliances) before leaving.
6, to familiarize themselves with the production site of the main air circuit breaker (commonly known as the main switch) location (such as construction sites, workshops, offices, dormitories, etc.).
Tag:
Previous article
Mobile:
Tel:
Add: Dongshe Town, Tongzhou District, Nantong City, Jiangsu Province
Contact: 86-13901468376 Mr. Zhu
Tel: 86-513-82506284 / 86-513-82506333
Fax: 86-513-82506666
E-mail: sales@ntzhongyi.com
Website: http://www.ntzhongyi.com
HUATAO GROUP
Online Message
Please fill in the form below, our staff will contact you within 24 hours and solve your problem as soon as possible.
Copyright©2024 Nantong Tongzhou Zhongyi Textile Machinery Co., Ltd.