The cloth rolling machine is used for various fabrics, non-woven fabrics, foam, leather, paper, reflective materials, acetate fabrics, reinforcing tapes, conductive fabrics and other materials to roll round packaging and various fabrics before cutting and binding strips. Roll, can be rolled into straight-grain or 45-degree twill fabric, photoelectrically opposite, can effectively align thick and thin materials with automatic code control, and can set the length of the roll. The cloth winding machine adopts electronic edge-aligning device, so that after the cloth and other materials are wound, the edges of the cloth are neat and consistent, and the soft roll or hard roll can be selected according to the type of cloth. It is equipped with a computer automatic control device to accurately count the length of the cloth. And automatic control, the speed of the cloth can be adjusted steplessly, the production efficiency is high, the manpower is saved, and the single-person operation is convenient. Twill rolls can be adjusted between 20 degrees and 70 degrees. Stainless steel cloth barrels are used, which will never rust and avoid staining the fabric. The planting machine and the fully automatic cutting and binding machine are a set of equipment. The winder should be operated by designated personnel, and non-operating personnel are not allowed to use it without permission. Before operation, turn on the power switch and let the cloth winder rotate one or two revolutions to check whether the machine is normal. Metal objects and other sundries are not allowed to be placed on and around the cloth winding machine to prevent affecting the cloth winding effect. Operators should do daily maintenance and sanitation, and neutral detergent should be used when cleaning the conveyor belt. If an abnormality is found during operation, the vehicle should be shut down immediately and the maintenance personnel should be notified for inspection. After get off work, remember to cut off the power and clean up.